This device complies with RSS 210 of Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication.Ĭomplies with the Canadian ICES-003 Class B specifications.Ĭet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. (2) cet appareil doit accepter toute interférence, y compris celles susceptibles de provoquer un fonctionnement non souhaité de l’appareil. (1) cet appareil ne doit pas provoquer d’interférences et Le fonctionnement est soumis aux deux conditions suivantes: (2)This device must accept any interference, including interference that may cause undesired operation of the device.Ĭet appareil est conforme aux norms CNR exemptes de licence d’Industrie Canada. (1) This device may not cause interference, and Operation is subject to the following two conditions:
This device complies with Industry Canada license-exempt RSS standard(s). The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.” “To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. Such modifications could void the user’s authority to operate the equipment.
Change router mac address archer c7 tv#
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Operation is subject to the following two conditions:ġ This device may not cause harmful interference.Ģ This device must accept any interference received, including interference that may cause undesired operation.Īny changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Increase the separation between the equipment and receiver.Ĭonnect the equipment into an outlet on a circuit different from that to which the receiver is connected.Ĭonsult the dealer or an experienced radio/ TV technician for help. Reorient or relocate the receiving antenna. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. 2.2 Installation Environment Requirements.